Make head DIY old doors myself

Do not have a Leitgefühl, if a bit removed and will not continue to use it? You said that the inner voice of conscience and not that you can actually use it again? This could make many new beautiful stuff from him. An example of this are the cabinets of old doors. The doors that you see here were originally about 90 cm wide and up to 200 cm high. We had no Hadrware installed. The work was then about 170 cm wide and 167 cm in height. They are still about 5 cm thick materials needed. 3-30 cm Verbbesserungsplatten. Box 1 matching wood screws (about 30-3 cm) 3 x 6 cm large black Torscharniere 2 black door hinges tools: circular saw, drill and 15/03/15 boards measuring about 170 cm on each side of the door, and then select the width. Check the hardware on how these lines and remove if necessary. To make it easier to remove the shredder on and jagged edges when cutting, you can attach a blanket or a blue ribbon at these locations. Then attach another marker on the tape. Cut the door on their length with a circular saw and a Linealfürhrung. Position the upper closure plate (cut) ends of the door so they are perfect for each other.

Do not place the 30 cm wide cover plates beyond 6 inches away from the edge

Its screen center came to the point of closure between the two doors. First then let the screws out of the holes of the two inner holes of the locking plates, then the other. Attach the cover plates rest on top and middle of the door Now attach the hinges and decorative handles on Now you can install the unit above. Then put the door on their positions and set the Torscharniere to an end. To determine the location of the closure plates, you must ensure that this does not cover the holes for the screws. You can determine the positions of the holes and Torscharniere in advance in advance. You can now where it needs to be drilled, Mark Select the items and make more Torscharniere here you meet the small "pilot hole". Attach the appropriate Torscharniere using the corresponding screw Do you have old boards to the hardware you want to keep? If yes, then you can skip the next step. For all others: You best to remove the existing Hadrware: Position Immersion to desired profiles on the side doors places. Mark the positions of the holes for the screws, drill pilot holes and fix recommended by the manufacturer of fashion. After accurate measurement, the cut is If you attach the design to the wall There is a method, which is called "hanging rails." With this, it comes to the connection of two door leaves, which have been cut to length with a 45 degree slope. Here we explain step by step how to do! First, you must install a central line at one end of the broad 3-15 cm board. Highlight the key points of this limit. It should then be cut by a line with an inclination of 45 degrees. Then tear the door in two different parts. Cut this oblong 150 cm. Now you can place the two sheets in the terminal reached. You can use the Torscharniere or the upper door frame. Set used with the appropriate screws. An additional card back Make sure the end of the long side of the door trim is further processed. Someone should help you in the desired location when installing the device. Only you can create it, if you take the different parts separately and individually attached to their body. Install head Attach the head to the desired position and hold it tight against the wall on which it is being fitted. The parts are perfect match. The lines of the wall and the furniture should monitor each other. Now remove the drive and use a level to cut the chassis. Now you can join the different levels on the wall with the appropriate tools Soon, it could also look like you – rustic romance
Or do you prefer the vintage atmosphere For lovers of the sea – a stylish nautical feel of Mason Bay Blog